B0110 - Short In Right-Side Air Bag Module Squib Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B0110 Possible Causes

  • Faulty Right-Side Air Bag Module
  • Right-Side Air Bag Module harness is open or shorted
  • Right-Side Air Bag Module circuit poor electrical connection
  • Faulty Air Bag Control Module

Cost of diagnosing the B0110 code

    Labor: 1.0

    The cost of diagnosing the B0110 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B0110 Possible Symptoms

  • Air Bag Warning Light ON

B0110 Meaning

The side air bag module squib circuit consists of the air bag sensor assembly and side air bag module. The squib circuit causes the side air bag to deploy when deployment conditions are satisfied. The Air Bag Control Module monitors the Right-Side Air Bag Module. The Air Bag Control Module sets the OBDII code when the Right-Side Air Bag Module is not to factory specifications.
OBDII Code B0110 - Short In Right-Side Air Bag Module Squib Circuit - Engine-Codes.com

B0110 Information for specific makes

  • B0110 LEXUS Short In Right-Side Air Bag Module Squib Circuit
  • B0110 SCION Short In Right-Side Air Bag Module Squib Circuit
  • B0110 TOYOTA Short In Right-Side Air Bag Module Squib Circuit

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information