Engine-Codes
 
OBDII Code List
 
B0102 CHEVROLET

B0102 CHEVROLET - Driver-Side EFS Incorrect Identification Message

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B0102 CHEVROLET Possible Causes

  • Faulty Driver-Side Electronic Frontal Sensor (EFS)
  • Driver-Side Electronic Frontal Sensor (EFS) harness is open or shorted
  • Driver-Side Electronic Frontal Sensor (EFS) circuit poor electrical connection
  • Faulty Sensing and Diagnostic Module (SDM)

Cost of diagnosing the B0102 CHEVROLET code

    Labor: 1.0

    The cost of diagnosing the B0102 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B0102 CHEVROLET Possible Symptoms

  • Air Bag Warning Light ON

B0102 CHEVROLET Meaning

Electronic Frontal Sensor (EFS), also known as a front end sensor, uses a unidirectional 2-wire circuit. EFS sensor modulates current on the interface to send identification, State Of Health (SOH) and deployment commands to Sensing and Diagnostic Module (SDM). The SDM serves as a power source and ground for EFS. When ignition is turned on and EFS detects power from SDM, EFS responds by performing internal diagnostics and sending identification to SDM. SDM considers identification message to be valid if received within 5 seconds of EFS powering up. EFS continually communicates a status message to SDM. When fault is detected, SDM will attempt to reset EFS twice by removing and applying power. If fault is still present, SDM will set a Diagnostic Trouble Code (DTC).
OBDII Code B0102 CHEVROLET - Driver-Side EFS Incorrect Identification Message - Engine-Codes.com

B0102 CHEVROLET More Information

Need more information on how to fix the B0102 CHEVROLET code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information