B00C2 - Passenger Seat Occupant Classification Sensor 'C'
Faulty Passenger Seat Occupant Classification Sensor 'C'
Passenger Seat Occupant Classification Sensor 'C' harness is open or shorted
Passenger Seat Occupant Classification Sensor 'C' circuit poor electrical connection
Faulty Air Bag Control Module
Air Bag Warning Light ON
The Occupant Classification System (OCS) is designed to classify the weight of the front seat passenger and automatically turn OFF the front passenger air bag under certain conditions. The Air Bag Control Module monitors the Passenger Seat Occupant Classification Sensor 'C'. The Air Bag Control Module sets the OBDII code when the Passenger Seat Occupant Classification Sensor 'C' is not to factory specifications.
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.