Engine-Codes - Generic - B009C

B009C - Left Side Restraints Sensor 6

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

B009C Possible Causes

  • Faulty Left Side Restraints Sensor 6
  • Left Side Restraints Sensor 6 harness is open or shorted
  • Left Side Restraints Sensor 6 circuit poor electrical connection
  • Faulty Air Bag Control Module

How is the B009C code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the B009C code

Labor: 1.0

The cost to diagnose the B009C code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Air Bag Warning Light ON

B009C Meaning

The Air Bag Control Module monitors the Left Side Restraints Sensor 6. The Air Bag Control Module sets the OBDII code when the Left Side Restraints Sensor 6 is not to factory specifications.

More Information

Need more information on how to fix the B009C code?
Get Access to Factory Service Manuals

Need more help?

Get the B009c code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.