|What are the Possible Causes of the B0098 INFINITI Code?
Faulty Front Door Satellite Sensor Right
Front Door Satellite Sensor Right harness is open or shorted
Front Door Satellite Sensor Right circuit poor electrical connection
Faulty Air Bag Diagnosis Sensor Unit
|How to Fix the B0098 INFINITI Code?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the B0098 INFINITI code?
The cost to diagnose the B0098 INFINITI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B0098 INFINITI code possible symptoms?
Air Bag Warning Light ON
|What Does the B0098 INFINITI Code Mean?
The Front Door Satellite Sensor Right is wired to the Air Bag Diagnosis Sensor Unit. The Air Bag Diagnosis Sensor Unit (Air Bag Control Module) monitors the Front Door Satellite Sensor Right. The Air Bag Diagnosis Sensor Unit sets the OBDII code when the Front Door Satellite Sensor Right is not to factory specifications.
Front Door Satellite Sensor Right
|Need more information with the B0098 INFINITI code?
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.