B0091 NISSAN - Left Front Side Air Bag Satellite Sensor

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B0091 NISSAN Possible Causes

  • Faulty Left Front Side Air Bag Satellite Sensor
  • Left Front Side Air Bag Satellite Sensor harness is open or shorted
  • Left Front Side Air Bag Satellite Sensor circuit poor electrical connection

First diagnose B0091 NISSAN code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the B0091 NISSAN code

    Labor: 1.0

    The cost of diagnosing the B0091 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B0091 NISSAN Possible Symptoms

  • Air Bag Warning Light ON

B0091 NISSAN Meaning

The front side air bag satellite sensor LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the front side air bag satellite sensor LH for internal failures and its circuits for communication errors.
OBDII Code B0091 NISSAN - Left Front Side Air Bag Satellite Sensor  - Engine-Codes.com

B0091 NISSAN More Information

Need more information on how to fix the B0091 NISSAN code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information