B0082 Mercury Code Meaning, Causes, Symptoms, & Tech Notes

What are the Possible Causes of the Code B0082 Mercury?

Faulty Passenger Seatbelt Load Limiter Deployment
Passenger Seatbelt Load Limiter Deployment harness is open or shorted
Passenger Seatbelt Load Limiter Deployment circuit poor electrical connection
Faulty Restraints Control Module (RCM)

How to Fix the B0082 Mercury Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Search B0082 Mercury Questions and Answers

What does this mean?

Code B0082 Mercury Tech Notes

B0082:11 Passenger Seatbelt Load Limiter Deployment Control: Circuit Short to Ground
B0082:12 Passenger Seatbelt Load Limiter Deployment Control: Circuit Short to Battery
B0082:13 Passenger Seatbelt Load Limiter Deployment Control: Circuit Open
B0082:1A Passenger Seatbelt Load Limiter Deployment Control: Circuit Resistance Below Threshold

What is the Cost to Diagnose the Code B0082 Mercury?

Labor: 1.0

The cost to diagnose the B0082 Mercury code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Mercury have Safety Recalls? → Check here

What are Code B0082 Mercury Possible Symptoms?

Air Bag Warning Light ON

What Does the B0082 Mercury Code Mean?

The Restraints Control Module (RCM) analyzes the deployment loop resistance to determine if a fault exists. The value displayed in the Parameter Identification (PID) is the deployment loop resistance measured by the Restraints Control Module (RCM). If the value displayed is lower or higher than the desired range, the Restraints Control Module (RCM) can set a Diagnostic Trouble Code (DTC). As the deployment loop resistance drifts farther outside the desired range, the chance for a Diagnostic Trouble Code (DTC) increases. Small variations in resistance can occur due to the effect of road vibrations on terminal fit. Crimps and terminals can be affected by stress and harness movement and can cause an increase in resistance due to wire strain. These variables can result in an intermittent fault. For this reason, the test requires the Parameter Identification (PID) value to be within the desired range before the fault is considered repaired, regardless if the module is reporting an on-demand Diagnostic Trouble Code (DTC) at the time of diagnosis. Following this direction helps make sure that minor changes in resistance do not create a repeat concern.

B0082 Mercury Code - Passenger Seatbelt Load Limiter Deployment Control

Need more Information on the B0082 Mercury Code?

Need more information on how to fix the B0082 Mercury code? Get Access to Factory Service Manuals

Need Help with the B0082 Mercury Code?

Get the B0082 Mercury code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.