B0077 CADILLAC Code - Left Front/Driver Side Impact Sensor Performance
|B0077 CADILLAC code possible causes
- Faulty Left Front/Driver Side Impact Sensor (SIS)
- Left Front/Driver Side Impact Sensor (SIS) harness is open or shorted
- Left Front/Driver Side Impact Sensor (SIS) circuit poor electrical connection
- Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)
|How is the B0077 CADILLAC code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the B0077 CADILLAC code
Labor: 1.0The cost to diagnose the B0077 CADILLAC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B0077 CADILLAC code possible symptoms?
- Air Bag Warning Light ON
|What is B0077 CADILLAC code meaning?The Inflatable Restraint Side Impact Sensor (SIS) utilizes a unidirectional 2-wire circuit. The SIS modulates current on the interface to send ID, State of Health, and deployment commands to the Inflatable Restraint Sensing and Diagnostic Module (SDM). The SDM serves as a power source and a ground for the SIS. When the ignition is turned on and input power from the SDM is first detected, the SIS responds by performing internal diagnostics and sending an ID to the SDM. The SDM considers the ID to be valid if the response time is less than 5 seconds. The SIS continually communicates status messages to the SDM, which determines if a fault is present in the SIS circuit. When a fault is detected, the SDM resets the SIS twice by removing and reapplying power. If the fault is still present, the SDM will set a Diagnostic Trouble Code (DTC).
|Need more information with the B0077 CADILLAC code?Need more information on how to fix the B0077 CADILLAC code?
Get Access to Factory Service Manuals
|Need help with a B0077 CADILLAC code?Get the B0077 Cadillac code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.