Engine-Codes -
Generic -
B0075
B0075 - Second Row Right Seatbelt Pretensioner Deployment Control
Table of contents
B0075 Possible Causes
- Faulty Second Row Right Seatbelt Pretensioner
- Second Row Right Seatbelt Pretensioner harness is open or shorted
- Second Row Right Seatbelt Pretensioner circuit poor electrical connection
How is the B0075 code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.What is the cost to diagnose the B0075 code
Labor: 1.0
The cost to diagnose the B0075 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Possible Symptoms
- Air Bag Warning Light ON
B0075 Meaning
The Air Bag Control Module monitors the Second Row Right Seatbelt Pretensioner. The Air Bag Control Module sets the OBDII code when the Second Row Right Seatbelt Pretensioner is not to factory specifications.More Information
Need more information on how to fix the B0075 code?Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.