B0061 FORD Possible Causes
- Faulty Passenger Seatbelt Tension Sensor (part of front passenger safety belt)
- Passenger Seatbelt Tension Sensor harness is open or shorted
- Passenger Seatbelt Tension Sensor circuit poor electrical connection
How is the B0061 FORD code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.Tech Notes
B0061:11 Passenger Seatbelt Tension Sensor: Circuit Short to GroundB0061:12 Passenger Seatbelt Tension Sensor: Circuit Short to Battery
B0061:13 Passenger Seatbelt Tension Sensor: Circuit Open
B0061:1C Passenger Seatbelt Tension Sensor: Circuit Voltage Out of Range
B0061:49 Passenger Seatbelt Tension Sensor: Internal Electronic Failure
What is the cost to diagnose the B0061 FORD code
Labor: 1.0
The cost to diagnose the B0061 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Possible Symptoms
- Air Bag Warning Light ON
B0061 FORD Meaning
The Belt Tension Sensor (BTS) operates in conjunction with the Occupant Classification System (OCS). The Occupant Classification System (OCS) interprets a variable voltage signal provided by the Belt Tension Sensor (BTS) to identify the possible presence of a child safety seat in the front passenger seat. The voltage output of the Belt Tension Sensor (BTS) is proportional to the amount of tension applied to the sensor by the belt: no belt tension causes a low voltage (approximately 0.95 volt) to be output, and high belt tension causes a high voltage (approximately 3.8 volts) to be returned to the Occupant Classification System Module (OCSM).More Information
Need more information on how to fix the B0061 FORD code?Get Access to Factory Service Manuals
Need more help?
Get the B0061 Ford code diagnosed by a professional: Find a repair shop in your areaPrecautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.