Engine-Codes - Chevrolet - B003A CHEVROLET

B003A CHEVROLET Code - Second Row Right Frontal Stage 2 Deployment Control

- Code Popularity: 1,527 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the B003A CHEVROLET Code?

  • Faulty Second Row Right Frontal Air Bag
  • Second Row Right Frontal Air Bag harness is open or shorted
  • Second Row Right Frontal Air Bag circuit poor electrical connection
  • Faulty Sensing and Diagnostic Module (SDM)

|How to Fix the B003A CHEVROLET Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the B003A CHEVROLET code?

Labor: 1.0

The cost to diagnose the B003A CHEVROLET code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B003A CHEVROLET code possible symptoms?

  • Air Bag Warning Light ON

|What Does the B003A CHEVROLET Code Mean?

When the ignition switch is turned to RUN position, Sensing and Diagnostic Module (SDM) performs tests to diagnose critical internal malfunctions. SDM then performs deployment loop voltage out of range test and deployment loop resistance measurement test. If voltage out of range test detects a short to voltage condition, the resistance measurement test will not be performed.

Second Row Right Frontal Stage 2 Deployment Control

|Need more information with the B003A CHEVROLET code?

Need more information on how to fix the B003A CHEVROLET code?
Get Access to Factory Service Manuals

|Need help with a B003A CHEVROLET code?

Get the b003a chevrolet code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.