B0030 CADILLAC - Second Row Left Side Airbag Deployment Control
Repair Importance Level: 3/3
Repair Difficulty Level:
3/3
Possible causes
Faulty Second Row Left Side Airbag
Second Row Left Side Airbag harness is open or shorted
Second Row Left Side Airbag circuit poor electrical connection
Faulty Sensing and Diagnostic Module (SDM)
Possible symptoms
Air Bag Warning Light ON
B0030 Cadillac Description
When the ignition switch is turned to RUN position, Sensing and Diagnostic Module (SDM) performs tests to diagnose critical internal malfunctions. SDM then performs deployment loop voltage out of range test and deployment loop resistance measurement test. If voltage out of range test detects a short to voltage condition, the resistance measurement test will not be performed.
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Related Information