Engine-Codes -
Cadillac -
B0029 CADILLAC
B0029 CADILLAC - Right Front/Passenger Side Deployment Loop Open
Table of contents
B0029 CADILLAC Possible Causes
- Faulty Right Front/Passenger Side Air Bag Module
- Right Front/Passenger Side Air Bag Module harness is open or shorted
- Right Front/Passenger Side Air Bag Module circuit poor electrical connection
How is the B0029 CADILLAC code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.What is the cost to diagnose the B0029 CADILLAC code
Labor: 1.0
The cost to diagnose the B0029 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Possible Symptoms
- Air Bag Warning Light ON
B0029 CADILLAC Meaning
When the ignition switch is turned to RUN position, Sensing and Diagnostic Module (SDM) performs tests to diagnose critical internal malfunctions. The SDM then performs deployment loop voltage out of range test and deployment loop resistance measurement test. If voltage out of range test detects a short to voltage condition, the resistance measurement test will not be performed.More Information
Need more information on how to fix the B0029 CADILLAC code?Get Access to Factory Service Manuals
Need more help?
Get the B0029 Cadillac code diagnosed by a professional: Find a repair shop in your areaPrecautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.