Engine-Codes - Buick - B0017 Buick

B0017 Buick Code - Passenger Frontal Deployment Loop Open

- Code Popularity: 3,513 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

What are the Possible Causes of the Code B0017 Buick?

  • Faulty Inflatable Restraint Instrument Panel
  • Inflatable Restraint Instrument Panel harness is open or shorted
  • Inflatable Restraint Instrument Panel circuit poor electrical connection
  • Faulty Sensing and Diagnostic Module (SDM)

How to Fix the B0017 Buick Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the Cost to Diagnose the Code B0017 Buick?

Labor: 1.0

The cost to diagnose the B0017 Buick code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Buick have Safety Recalls? → Check here

What are Code B0017 Buick Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B0017 Buick Code Mean?

The Inflatable Restraint Instrument Panel (I/P) module deployment loop consists of a dual stage I/P module, I/P module high control, and I/P module low control circuits for both stages 1 and 2. There are 2 shorting bars used within the I/P module connector which will short together the I/P module high and I/P module low control circuits for both stages 1 and 2 when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing. When the ignition is turned ON, the inflatable restraint Sensing and Diagnostic Module (SDM) performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. If a malfunction is detected, a Diagnostic Trouble Code (DTC) will be stored in memory.

B0017 Buick Code - Passenger Frontal Deployment Loop Open

Need more Information on the B0017 Buick Code?

Need more information on how to fix the B0017 Buick code? Get Access to Factory Service Manuals

Need Help with the B0017 Buick Code?

Get the B0017 Buick code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.