B0013 - Driver Frontal Deployment Loop Stage 2
B0013 Possible Causes
- Faulty Steering Wheel Inflator Module
- Faulty Steering Wheel Module Coil
- Steering Wheel Inflator Module harness is open or shorted
- Steering Wheel Inflator Module circuit poor electrical connection
- Faulty Sensing and Diagnostic Module (SDM)
How is the B0013 code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
DTC B0013 02 Driver Frontal Deployment Loop Stage 2 Short to Ground
DTC B0013 04 Driver Frontal Deployment Loop Stage 2 Open Circuit
DTC B0013 0D Driver Frontal Deployment Loop Stage 2 Resistance Above Threshold
DTC B0013 0E Driver Frontal Deployment Loop Stage 2 Resistance Below Threshold
What is the cost to diagnose the B0013 code
Labor: 1.0The cost to diagnose the B0013 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Air Bag Warning Light ON
B0013 MeaningIf a malfunction is detected, a Diagnostic Trouble Code (DTC) will be stored in non-volatile memory. During a frontal crash of sufficient force the inflatable restraint Sensing and Diagnostic Module (SDM) will allow current to flow through the deployment loop in order to deploy the steering wheel module. The SDM performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. There are 2 shorting bars used within each connector which will short together both steering wheel module stage 1 high circuit and steering wheel module stage 1 low circuit and both steering wheel module stage 2 high circuit and steering wheel module stage 2 low circuit when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing.
More InformationNeed more information on how to fix the B0013 code?
Get Access to Factory Service Manuals
Information for specific makes
- B0013 BUICK Driver Frontal Deployment Loop Stage 2
- B0013 CADILLAC Driver Frontal Deployment Loop Stage 2
- B0013 CHEVROLET Driver Frontal Deployment Loop Stage 2
- B0013 GMC Driver Frontal Deployment Loop Stage 2
- B0013 PONTIAC Driver Frontal Deployment Loop Stage 2
- B0013 SATURN Driver Frontal Deployment Loop Stage 2
Need more help?Get the B0013 code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.