|What are the Possible Causes of the Code B0011 Infiniti?
Faulty Passenger Air Bag Module
Passenger Air Bag Module harness is open or shorted
Passenger Air Bag Module circuit poor electrical connection
Faulty Air Bag Diagnosis Sensor Unit
|How to Fix the B0011 Infiniti Code?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the Cost to Diagnose the Code B0011 Infiniti?
The cost to diagnose the B0011 Infiniti code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Passenger Air Bag Module is dual stage or single stage and is wired to the Air Bag Diagnosis Sensor Unit. The Air Bag Diagnosis Sensor Unit will monitor for opens and shorts in detected lines to the Passenger Air Bag Module.
B0011 Infiniti Code - Passenger Air Bag Module
|Need more Information on the B0011 Infiniti Code?
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.