Engine-Codes - Generic - B0002

B0002 Code - Driver Frontal Stage 2 Deployment Control: Signal Cross Coupled

- Code Popularity: 46,919 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

What are the Possible Causes of the Code B0002?

  • Faulty Driver Sir Air Bag
  • Driver Sir Air Bag harness is open or shorted
  • Driver Sir Air Bag circuit poor electrical connection

How to Fix the B0002 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the Cost to Diagnose the Code B0002?

Labor: 1.0

The cost to diagnose the B0002 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Car have Safety Recalls? → Check here

When is the B0002 Code Detected?

If the Restraints Control Module detects a short between the driver air bag stage 2 circuits and the circuits of another SRS component, it sets this DTC and the Detected Trouble Code (DTC) of the corresponding SRS component.

What are Code B0002 Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B0002 Code Mean?

The Restraints Control Module (RCM) monitors all deployable device and sensor circuits for a signal cross coupled (short) between circuits. If the RCM detects a short between the circuits of one device and another device, it will store a DTC for each of the signal cross coupled faults in memory. The RCM sends a message to the Instrument Panel Cluster (IPC) to illuminate the air bag warning indicator. When a normal loop fault is present (one loop is either shorted to battery/ground, open circuit or low resistance), then signal cross coupled diagnostics will not be active. Once the normal loop fault is repaired, then the signal cross coupled diagnostics will resume.

B0002 Code - Driver Frontal Stage 2 Deployment Control: Signal Cross Coupled

Need more Information on the B0002 Code?

Need more information on how to fix the B0002 code? Get Access to Factory Service Manuals

Code B0002 Information for Specific Makes

Need Help with the B0002 Code?

Get the B0002 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.