U2010:11 Illumination Switch Circuit Short to Ground
U2010:15 Illumination Switch Circuit Short to Battery or Open
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the U2010 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The Body Control Module (BCM) supplies voltage to all non-networked illumination sources through 1 of 3 circuits. Each circuit has separate Field-Effect Transistor (FET) protection that is used to disable the output driver for the circuit if a short to ground is detected. The Diagnostic Trouble Code (DTC) will set in continuous memory and on-demand when the BCM detects an excessive or a lower than expected current draw from a switch illumination circuit.
Need more information on how to fix the U2010 code? Get Access to Factory Service Manuals
Get the U2010 code diagnosed by a professional: Find a repair shop in your area