Engine-Codes - Buick - P2104 Buick

P2104 Buick Code - Throttle Actuator Control System - Forced Engine Idle

- Code Popularity: 1,570 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P2104 Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Throttle Actuator Control (TAC)
  • Throttle Actuator Control (TAC) harness is open or shorted
  • Throttle Actuator Control (TAC) circuit poor electrical connection
⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC P2104 Buick?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P2104 Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P2104 Buick code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P2104 Buick Code Mean?

The Throttle Actuator Control (TAC) system uses vehicle electronics and components to calculate and control the position of the throttle blade. This eliminates the need for a mechanical cable attachment from the accelerator pedal to the throttle body. This system also performs the cruise control functions as well.

The TAC system components include, but are not limited to the following:

- The accelerator pedal position (APP) sensors
- The throttle body
- The Powertrain Control Module (PCM)

Each of these components interface together to ensure accurate calculations and control of the throttle position (TP).

Throttle Body Assembly

The throttle body for the throttle actuator control (TAC) system is similar to a conventional throttle body with several exceptions. One exception being the use of a motor to control the throttle position instead of a mechanical cable. Another exception is the throttle position (TP) sensor. The TP sensor is mounted in the throttle body assembly. The TP sensor is 2 individual TP sensors within the throttle body assembly. Two separate signal, low reference, and 5-volt reference circuits are used to connect the TP sensors and the Powertrain Control Module (PCM). TP sensor 2 signal voltage increases as the throttle opens. TP sensor 1 signal voltage decreases as the throttle opens.

P2104 Buick Code - Throttle Actuator Control System - Forced Engine Idle

Need more Information on the Code?

Need more information on how to fix the P2104 Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2104 Buick code diagnosed by a professional: Find a repair shop in your area