Engine-Codes - Generic - P1626

P1626 Code - Theft Deterrent Fuel Enable Signal Not Received

- Code Popularity: 37,044 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1626?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty ignition switch
  • Ignition switch harness is open or shorted
  • ignition switch circuit poor electrical connection
  • Incorrect ignition key
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC P1626?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1626 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1626 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1626 Code Mean?

The Body Control Module (BCM) produces the theft deterrent fuel enable signal when the ignition is ON and the proper key resistor pellet is sensed. The Powertrain Control Module (PCM) monitors the fuel enable signal during crank. If the proper signal is present on the theft deterrent fuel enable circuit, the PCM enables fuel delivery to allow the engine to start. If the PCM detects that the fuel enables signal is not present or incorrect while the engine is running, DTC P1626 will be set. DTC P1626 can cause a no-start condition or normal operation depending on when the loss of the fuel enable signal was detected. The engine will continue to start and run if the condition that set DTC P1626 occurred after the BCM sensed the proper key resistor pellet and signaled the PCM to continue fuel delivery. The engine will start and immediately stall if the condition that set DTC P1626 occurred before the BCM sensed the proper key resistor pellet. With this condition present, the PCM will inhibit fuel delivery and the BCM will disable the starter.

P1626 Code - Theft Deterrent Fuel Enable Signal Not Received

Need more Information on the Code?

Need more information on how to fix the P1626 code? Get Access to Factory Service Manuals

Code P1626 Information for Specific Makes

Need Help with the Code?

Get the P1626 code diagnosed by a professional: Find a repair shop in your area