Engine-Codes - Ford - P1506 2010 Ford Fusion

P1506 2010 Ford Fusion Code - Idle Air Control Overspeed Error

- Code Popularity: 3,132 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1506 2010 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Idle Air Control (IAC) valve
  • IAC valve harness is open or shorted
  • IAC valve circuit poor electrical connection
  • Intake leaks
  • Stuck PCV Valve

Code Tech Notes

The P1506 code means that the engine idle is out of factory specification. Sometimes the Idle Air Control (IAC) may have carbon built up. Disconnect the car battery, remove the valve, clean, re-install valve, and drive the vehicle for about 5 minutes with the headlights and A/C ON to get the idle relearned.
Also, check for intake leaks or stuck PCV Valve.
If the problem persistss, the IAC valve may need to be replaced.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1506 2010 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1506 2010 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1506 2010 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The P1506 code sets when the Powertrain Control Module (PCM) detects an engine idle speed that is greater than the desired RPM.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1506 2010 Ford Fusion Code Mean?

The Idle Air Control Valve (IACV) valve assembly controls the engine idle speed and provides a dashpot function. The IAC valve assembly meters intake air around the throttle plate through a bypass within the IAC valve assembly and throttle body. The Powertrain Control Module (PCM) determines the desired idle speed or bypass air and signals the IAC valve assembly through a specified duty cycle. The IAC valve responds by positioning the IAC valve to control the amount of bypassed air. The PCM monitors engine RPM and increases or decreases the IAC duty cycle in order to achieve the desired RPM.

P1506 2010 Ford Fusion Code - Idle Air Control Overspeed Error

Need more Information on the Code?

Need more information on how to fix the P1506 2010 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1506 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area