Note: For LS6/LS8 and Thunderbird, the FPDM functions are incorporated in the Rear Electronics Module (REM). Also, the REM does not use an FPM circuit. Diagnostic information is sent on the communication link.
P1237 indicates that the FPDM has detected a fuel pump secondary circuit fault. The FPDM will send a message to the PCM through the FPM circuit, indicating that this failure has been detected. The PCM will set the DTC when the message is received.
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the P1237 2000 Ford F150 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
Fuel pump driver module has detected a fault in the fuel pump secondary circuit
Fuel Pump Driver Modules (FPDM) controls the voltage to the Fuel Pump in order to maintain proper fuel pressure over the full operating range of the engine. The P1237 code indicates the FPDM detected a fuel pump secondary circuit concern. The FPDM sends a message to the Powertrain Control Module (PCM) through the Fuel Pump Monitor (FPM) circuit indicating this concern was detected. The PCM sets the DTC when the message is received.
Need more information on how to fix the P1237 2000 Ford F150 code? Get Access to Factory Service Manuals
Get the P1237 2000 Ford F150 code diagnosed by a professional: Find a repair shop in your area