P0741 HYUNDAI - Torque Converter Clutch Solenoid Stuck Off
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem
The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.
My 2009 sonata 2.4 runs fine. Code po741 is on. But the car runs fine. I have a code reader on my iPhone , and can not n...Read Answer >>
The check engine light intermittently comes on and has been diagnosed with P0741 at Advanced auto parts. The light does...Read Answer >>
I got this code, however the car is running very smoothly with no symptoms at all! I checked the fluid and it was good t...Read Answer >>