Engine-Codes - Generic - B1414

B1414 Code - Driver Side Restraints Sensor 1

- Code Popularity: 17,002 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B1414?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Driver Side Restraints Sensor 1
  • Driver Side Restraints Sensor 1 harness is open or shorted
  • Driver Side Restraints Sensor 1 circuit poor electrical connection
  • Faulty Restraint Control Module (RCM)

Code Tech Notes

B1414:11 Driver Side Restraints Sensor 1 Circuit Short to Ground
B1414:93 Driver Side Restraints Sensor 1 No Operation

⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC B1414?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B1414 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B1414 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1414 Code Mean?

The Restraint Control Module (RCM) monitors the driver front door and RH C-pillar side impact sensors and circuits for the following faults: Open circuit, Short to voltage, Short to ground, Faulted driver front door side impact sensor, Faulted RH C-pillar side impact sensor. If a fault is detected, the RCM stores DTC B1414 in memory and sends a message to the Instrument Panel Cluster (IPC) to illuminate the airbag warning indicator. The RCM communicates with each impact sensor. If the RCM is unable to communicate with the sensor, a Diagnostic Trouble Code (DTC) is stored in memory. A Continuous Memory Diagnostic Trouble Code (CMDTC) no operation can be set by a short to voltage on the return circuit of the impact sensor.

B1414 Code - Driver Side Restraints Sensor 1

Need more Information on the Code?

Need more information on how to fix the B1414 code? Get Access to Factory Service Manuals

Code B1414 Information for Specific Makes

Need Help with the Code?

Get the B1414 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.